Tilt Steering Column: Inspection

INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.

Fig 1: Inspecting Steering Lock Mechanism Operation
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
IF NECESSARY, REPLACE KEY CYLINDER
1. Place the ignition key at the ACC position.
2. Using a screwdriver, push down the stop pin of the cylinder, and pull out the key cylinder.
3. Install a new cylinder.
HINT:

Make sure the key is at the ACC position.

Fig 2: Placing Ignition Key At ACC Position
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT IGNITION SWITCH (See INSPECTION )
IF NECESSARY, REPLACE IGNITION SWITCH
1. Remove the 2 screws and ignition switch.
2. Install a new ignition switch with the 2 screws.
INSPECT KEY UNLOCK WARNING SWITCH (See INSPECTION )
IF NECESSARY, REPLACE KEY UNLOCK WARNING SWITCH
1. Slide out the key unlock warning switch.
2. Slide in a new key unlock warning switch.
INSPECT KEY INTERLOCK SOLENOID (See INSPECTION )
IF NECESSARY, REPLACE KEY INTERLOCK SOLENOID
1. Remove the 2 screws and key interlock solenoid.
2. Install a new key interlock solenoid with the 2 screws.
INSPECT TRANSPONDER KEY COIL (See INSPECTION TRANSPONDER KEY COIL CONTINUITY )
IF NECESSARY, REPLACE TRANSPONDER KEY AMPLIFIER
INSPECT UPPER BEARING
1. Check the bearing rotation condition and check for abnormal noise.
  If the bearing is worn or damaged, replace the column upper tube.
2. Coat the bearing with molybdenum disulfide lithium base grease.
Fig 3: Inspecting Upper Bearing Rotation Condition
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT LOWER BEARING
1. Check the bearing rotation condition of the main shaft assembly and check for abnormal noise.
  If necessary, replace bearing.
2. Coat the bearing with molybdenum disulfide lithium base grease.
Fig 4: Inspecting Lower Bearing Rotation Condition
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002