Testing Procedure
WARNING: This page is about a different variant/trim than selected.
To ensure correct diagnosis and repair, testing should be done in the following sequence:
- Record Customer Complaint Ensure all customer complaints or observations are recorded. Test drive vehicle with customer when necessary for malfunction verification.
- Retrieve Diagnostic Trouble Codes Connect appropriate scan tool. Retrieve codes and record any freeze-frame data (if applicable). See RETRIEVING DIAGNOSTIC TROUBLE CODES .
- Clear Trouble Codes Clear codes. See CLEARING DIAGNOSTIC TROUBLE CODES .
- Visual Inspection Inspect all connectors of suspect circuit or component. Ensure all connections are clean and tight.
- Confirm Symptoms & Trouble Codes Perform road test. Determine if original symptoms are still present. Retrieve codes.
- Diagnose & Repair Diagnostic Trouble Codes Perform diagnosis and repair procedures as necessary. See CIRCUIT TESTS . If no codes are present, proceed to TESTS W/O CODES - 1.8L article for diagnosis by symptom (i.e., ROUGH IDLE, NO START, etc.).
- Verification Procedure After repairs have been completed, clear all diagnostic trouble codes. See CLEARING DIAGNOSTIC TROUBLE CODES . Perform road test. Ensure no codes are present and all symptoms and/or complaints have been repaired.