Operating Cylinder: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.
NOTE:
- Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder.
Grease:

NICHIMOLY N-130 or equivalent
- Be sure to install the clutch hose with the mark side facing upward.
- Be careful not to twist the clutch hose during installation.
Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.3 ft-lb)

Fig 1: Release Lever And Operating Cylinder Bolts With Torque Specification
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Clutch Hose And Operating Cylinder With Mark
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that the clutch operates properly. < Ref. to CLUTCH FLUID AIR BLEEDING . >