5MT Model

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
NOTE:
- The illustration below is for a Non-turbo model. However, perform the same procedures for the Turbo model.
- Before installing the operating cylinder, apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and operating cylinder.
Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.3 ft-lb)

Fig 1: Identifying Release Lever And Operating Cylinder Bolts Tightening Torque
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that the clutch operates properly. Refer to CLUTCH FLUID AIR BLEEDING .