Differential Case Assembly

Remove the taper roller bearing using the ST and a press.
ST 498077000 REMOVER

Fig 1: Identifying ST 498077000 Remover
Courtesy of SUBARU OF AMERICA, INC.
Secure the case in a vise, remove the hypoid driven gear tightening bolts, then separate the hypoid driven gear into case (RH) and case (LH).

Fig 2: Identifying Differential Case And Hypoid Driven Gear
Courtesy of SUBARU OF AMERICA, INC.
Pull out the straight pin and shaft, and then remove the differential bevel gear, washer and differential bevel pinion.

Fig 3: Identifying Differential Case
Courtesy of SUBARU OF AMERICA, INC.