LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Security And Locks >> Security Control Unit >> Procedure >> Function Setting (ECM Customizing)

Function Setting (ECM Customizing)

  1. Connect the Subaru Select Monitor to the data link connector.
  2. Turn the ignition switch to ON.
  3. On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
  4. On the «System Selection Menu» display screen, select the {keyless unit mode} and press the [YES] key.
  5. On the «Integ. Unit mode failure diag» display screen, select the {ECM customizing} and press the [YES] key.
  6. Change the setting with UP/DOWN key and press the [YES] key.
    • List of function setting item (ECM customizing)
    DATA LIST

    No. Data Initial setting value Customize setting Remarks
    1 Security Alarm Setup ON ON Security alarm (hazard and horn) in active condition.
    OFF Security alarm in inactive condition
    2   Alarm monitor delay setting ON After doors are locked by keyless entry system operation, alarm monitor starts in following time.
    ON Delay time is 30 seconds.
    OFF Delay time is 0 seconds.
    3 Impact Sensor Setup OFF ON Enabled when Impact Sensor Setup is set to "ON". Impact sensor function becomes activated.
    OFF Impact sensor in inactive condition (Make sure to set models without the impact sensor to "OFF").
    4 Impact Sensor Setup (OP) OFF ON Vehicle is controlled in impact sensor equipped mode. (Make sure to set models without the impact sensor to "OFF'. If impact sensor is set to "ON", hazard and/or horn operates after doors are locked by keyless entry system operation (Alarm monitor start).
    OFF Vehicle is controlled in no impact sensor mode.
    5 Passive arming OFF ON An automatic arming feature which arms automatically even without the user intentionally locking (ARM)
    OFF Enabled when passive arming is set to "ON."
  7. After setting, make sure that vehicle equipment matches the changed settings in the {Current Data Display & Save}.
    CAUTION:
    • The above settings most match the actual vehicle equipment for proper operation.
    • Do not change settings other than the above while setting equipment.
    • When installing a new keyless unit, perform initial setting again.
    • In passive mode, the system will automatically activate the security alarm but WILL NOT automatically lock the doors. Failure to lock the doors manually will result in a high security risk.
    NOTE: For details concerning operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".
  8. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.
scientia non olet · About LEMON Manuals