LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Security And Locks >> Keyless Entry System >> Inspection >> Check Keyless Transmitter Battery And Function

Check Keyless Transmitter Battery And Function

DIAGNOSTIC PROCEDURE CHART

Step Check Yes No
1 CHECK KEYLESS TRANSMITTER BATTERY. 
  1. Remove the battery from the keyless transmitter. <Ref. to REMOVAL  KEYLESS TRANSMITTER. >
  2. Check the battery voltage. <Ref. to INSPECTION  KEYLESS TRANSMITTER. >
 Is the voltage more than 2.5 V? Go to step 2.  Replace the keyless transmitter battery.
2 CHECK KEYLESS TRANSMITTER. 
Register a keyless transmitter which operated normally on other vehicles to the inspection target vehicle. <Ref. to REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR  REPLACEMENT, KEYLESS TRANSMITTER. >
  1. Close all the doors and rear gate of inspection target vehicle.
  2. Using the keyless transmitter, lock and unlock the doors and rear gate of vehicle.
 Is the inspection target vehicle operates lock and unlock normally? Go to step 3.  Due to vehicle malfunction, continue the keyless entry system diagnosis.
3 CHECK KEYLESS TRANSMITTER. 
Register the keyless transmitter of the inspection target vehicle to an other vehicle for which the keyless system operates normally. <Ref. to REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR  REPLACEMENT, KEYLESS TRANSMITTER. >		 Is the keyless transmitter registered correctly? Go to step 4.  Replace the keyless transmitter. <Ref. to REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR  REPLACEMENT, KEYLESS TRANSMITTER. >
4 CHECK KEYLESS TRANSMITTER. 
Check the registered keyless transmitter.
  1. Close all the doors and rear gate of the vehicle for which the keyless system is known to operate normally.
  2. Using the keyless transmitter, lock and unlock the doors and rear gate of vehicle.
 Does the vehicle operates lock and unlock normally? The keyless transmitter is OK. Replace the keyless transmitter. <Ref. to REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR  REPLACEMENT, KEYLESS TRANSMITTER. >
CAUTION: Be sure to reset the keyless transmitter of the other vehicle that was registered to the inspection target vehicle, and the vehicle for which the keyless transmitter was registered for inspection, to the condition before performing the inspection. (Register the keyless transmitter again.)
scientia non olet · About LEMON Manuals