LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> B9 Tribeca Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission 5AT >> Rear Vehicle Speed Sensor >> Installation

Rear Vehicle Speed Sensor: Installation

  1. Pass the harness assembly through the hole in transmission case.
    Fig 1: Identifying Harness Assembly
    G05002532Courtesy of SUBARU OF AMERICA, INC.
  2. Install the securing bolt of transmission main case.

    Tightening torque: 7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 2: Locating Bolt Securing Harness
    G05022254Courtesy of SUBARU OF AMERICA, INC.
  3. Install the control valve body.

    Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb) 

    NOTE: Be careful not to catch harness in.
    Fig 3: Identifying Control Valve Body Bolts
    G05032080Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the control valve connector and front vehicle speed sensor connector.
    Fig 4: Disconnecting/Connecting Control Valve Connector And Front Vehicle Speed Sensor Connector
    G05032081Courtesy of SUBARU OF AMERICA, INC.
  5. Apply proper amount of liquid gasket to the entire oil pan mating surface.

    Liquid gasket: THREE BOND 1217B (Part No. K0877YA020) 

    Fig 5: Applying Liquid Gasket To Entire Oil Pan Mating Surface
    G05022243Courtesy of SUBARU OF AMERICA, INC.
  6. Install the oil pan by equally tightening the bolts.

    Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb) 

  7. Install the rear vehicle speed sensor and turbine speed sensor 1, and then fasten the harness.

    Tightening torque: 7 N.m (0.7 kgf-m, 5.2 ft-lb) 

  8. Install a new aluminum washer and oil cooler pipe.

    Tightening torque: 40 N.m (4.1 kgf-m, 29.5 ft-lb) (ATF inlet pipe) 45 N.m (4.6 kgf-m, 33.2 ft-lb) (ATF outlet pipe) 

  9. Install the oil charge pipe. < Refer to INSTALLATION  , Oil Charge Pipe. >
  10. Install the transmission rear crossmember bolt.

    Tightening torque: 70 N.m (7.1 kgf-m, 51.6 ft-lb) 

  11. Install the propeller shaft. < Refer to INSTALLATION , Propeller Shaft. >
  12. Install the heat shield cover.
  13. Install the rear exhaust pipe and muffler. < Refer to INSTALLATION , Rear Exhaust Pipe. > < Refer to INSTALLATION , Muffler. >
  14. Lower the vehicle.
  15. Install the transmission connector to the stay, and then connect the connector.
  16. Install the air intake chamber. < Refer to INSTALLATION , Air Intake Chamber. >
  17. Pour ATF from the oil charge pipe. < Refer to REPLACEMENT , AUTOMATIC TRANSMISSION FLUID. >
  18. Check the level and leaks of ATF. < Refer to INSPECTION , AUTOMATIC TRANSMISSION FLUID. >
scientia non olet · About LEMON Manuals