LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Automatic Transmission) >> Extension Case >> Installation

Extension Case: Installation

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
    NOTE: Install thrust needle bearing in the correct direction.
  2. Install new gasket.
  3. Install the extension case to the transmission case.
  4. Tighten bolts to secure the case.
    1. Tightening torque: 25 N.m (2.5 kgf.m, 18.1 ft.lb) 
    Fig 1: Installing Extension Case To Transmission Case
    G00917633Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear vehicle speed sensor.
    1. Tightening torque: 7 N.m (0.7 kgf.m, 5.1 ft.lb) 
    • MPT MODEL
      Fig 2: Installing Rear Vehicle Speed Sensor - MPT Model
      G00917634Courtesy of SUBARU OF AMERICA, INC.
    • VTD MODEL
      Fig 3: Installing Rear Vehicle Speed Sensor - VTD Model
      G00917635Courtesy of SUBARU OF AMERICA, INC.
  6. Install the transmission assembly. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals