Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure Sensor Replacement

Removal Procedure




1. Remove the intake manifold cover.
2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
3. Remove the MAP sensor attaching screw.
4. Remove the MAP sensor and MAP sensor seal from the upper intake manifold.

Installation Procedure




1. Install the MAP sensor and MAP sensor seal into the upper intake manifold.

Notice: Refer to Fastener Notice.

2. Install the MAP sensor attaching screw.

Tighten the attaching screw to 6.5 N.m (57 lb in).

3. Connect the MAP sensor electrical connector.
4. Install the intake manifold cover.