Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTREMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Remove the MAP sensor bolt.
4. Remove the MAP sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the MAP sensor with the bolt.
Tighten
Tighten the MAP sensor bolt to 10 N.m (89 lb in).
2. Connect the MAP sensor electrical connector.
3. Connect the negative battery cable.