SET Operation

To activate the ASCD, all of following conditions must exist:

• ASCD control unit receives ASCD CRUISE/ON/OFF switch ON signal
• Power supply to ASCD control unit terminal 8 [Brake and clutch pedal is released (M/T), and brake pedal is released and A/T selector lever is in other than P and N position. (A/T)]
• Vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH). (Signal from combination meter)

When the SET/COAST switch is depressed, ground is supplied:

• to ASCD control unit terminal 11
• from ASCD steering switch terminal 4.

Then ASCD motor actuator is activated to control throttle wire and ASCD control unit supplies ground:

• to combination meter terminal 7 to illuminate SET indicator.