LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1994 >> Sentra SE-R, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - Re4F03V >> Testing >> Stall Speed Test >> Stall Speed Test Procedure

Stall Speed Test Procedure

  1. Check engine and transaxle fluid levels. Ensure engine and transaxle are at normal operating temperatures. Set parking brake and block wheels.
  2. Install tachometer so it is visible to driver. Start engine, apply foot brake and move selector lever to "D" position. Gradually depress accelerator pedal to wide-open throttle position while applying foot brake. Note engine stall speed and release accelerator pedal immediately. Stall speed should be 1900-2200 RPM.
  3. Place selector lever in "N" position and run engine at idle for one minute to allow transaxle to cool. Repeat stall speed test procedure in "2", "1" and "R" positions, allowing transaxle to cool between each test.
CAUTION: DO NOT  hold wide-open throttle for more than 5 seconds during test.
scientia non olet · About LEMON Manuals