DTC inspection
- Using the M-MDS, perform a DTC inspection and verify if any auto leveling control module-related DTCs are detected. (Refer to [DTC INSPECTION
] in the appropriate troubleshooting information
)
DTC is detected
- If DTC U3000:42 or U3000:49 is detected, replace the auto leveling control module. (See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION )
- If the detected DTC is other than U3000:42 or U3000:49, inspect for possible causes of the detected DTC starting from the top. (Refer to DTC TABLE [ALH/AFS/ALV]
in the appropriate troubleshooting information
)
- If the malfunction is not resolved, replace the auto leveling control module. (See AUTO LEVELING CONTROL MODULE REMOVAL/INSTALLATION )
No DTC is detected
- Perform a visual inspection. (See VISUAL INSPECTION )