| 1 |
CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE
- Connect the M-MDS (IDS) to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE .)
- Switch the ignition ON using a key (the key can be either the valid key or an unprogrammed key).
NOTE:
- If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1
min. However, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC):
- Select the "Body"
- Select the "Security"
- Select the "PATS Functions"
- Select either of the following from the M-MDS menu to change the additional key programming procedure.
- When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled.
- When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled.
- Perform the security access according to the directions on the M-MDS screen.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
- Switch the ignition to off.
|
Procedure is completed |