| 2 |
PERFORM ADDITIONAL KEY PROGRAMMING
- Connect the M-MDS (IDS) to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE .)
- Insert key 1 into the key slot and depress the clutch.
NOTE:
- The keyless indicator light (green) illuminates for approx. 5 s, then turns off.
- After verifying that the keyless indicator light (green) has illuminated, release the clutch within approx. 5 s and switch the ignition from off↓ACC↓ON.
- Pull out key 1 from the key slot and insert key 2 into the slot.
NOTE:
- When key 1 is pulled out of the key slot, the advanced key system warning alarm sounds and the keyless indicator light (red) begins flashing, however continue with the procedure.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC):
- Select the "Body"
- Select the "Security"
- Select the "PATS Functions"
- Then, select an item from the screen menu.
item
- Program Additional Ignition Key
- Perform the security access according to the directions on the M-MDS screen.
NOTE:
- After executing the above menu, "This operation is successful" is displayed. This indicates that the programming of the key that currently has the ignition switched on is completed.
- If an additional key is to be programmed, continue to perform the procedure according to the directions on the M-MDS screen. To finish the key programming, go to the next step.
|
Yes |
Change the key and repeat Step 2. |