Ignition Control Module
WARNING: This page is about a different variant/trim than selected.
Check ignition coil, PCM and high tension lead connections. Check secondary coil winding and high tension lead resistance. Measure voltage at appropriate PCM terminals. See PCM TERMINAL IDENTIFICATION table. If all measurements are within specification, and misfire still occurs, replace distributor or ignition coil.
PCM TERMINAL IDENTIFICATION
| Wire Color To Ground (1) | KOEO Volts | KOER (Idle) Volts | |||
|---|---|---|---|---|---|
| A/T | |||||
| Yellow/Red | B+ | B+ | |||
| Red (24) | 0 Or B+ | 0.8-1.0 | |||
| Pink/Blue (50) | Below 1 | 0.6-0.7 | |||
| M/T | |||||
| Orange (2E) | 1 Or 5 | 2 | |||
| Yellow/Red (2F) | Below 1 | 0.4 | |||
| Black/Blue (2O) | 1.0-1.5 | 1.5-5.0 | |||
|
|||||