Rear Acceleration Sensor: Installation
WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL ACCELERATION SENSOR ASSEMBLY
- Install the acceleration sensor with bracket with the bolt.
Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:- Avoid any impact to the acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
- Connect the sensor connector.
- Install the acceleration sensor with bracket with the bolt.
- INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH (See INSTALLATION )
- INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
- INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (See INSTALLATION )
- INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (See INSTALLATION )
- INSTALL NO. 1 COOLER COVER (w/ Rear Cooler) (See INSTALLATION )
- INSTALL DECK TRIM SIDE BOARD RH (See INSTALLATION )
- INSTALL ROPE HOOK ASSEMBLY (See INSTALLATION )
- INSTALL ROPE HOOK (See INSTALLATION )
- INSTALL BATTERY SERVICE HOLE COVER (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ). - INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
- INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )
- CHECK SRS WARNING LIGHT
- Check the SRS warning light (see DIAGNOSIS SYSTEM ).