Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR (2UZ-FE)

REPLACEMENT
1. REMOVE ENGINE UNDER COVER ASSY REAR




2. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt and crankshaft position sensor.

3. INSTALL CRANKSHAFT POSITION SENSOR
a. Install crankshaft position sensor with bolt.

Torque: 6.5 N.m (65 kgf.cm, 58 in.lbf)

4. INSTALL ENGINE UNDER COVER ASSY REAR