Front Drive HALFSHAFTS: Specifications
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATION
| Item | Specification |
|---|---|
| Type | Fully floating, fixed length, solid shafts incorporating constant velocity joints at each end of shaft |
RECOMMENDED LUBRICANT
| Item | Specification |
|---|---|
| Outboard joint | Use grease supplied with replacement boot kit (Optimol MS139G) |
| Inboard joint | Use grease supplied with replacement boot kit (1 Luber C MS132G) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| * Stabilizer bar link nuts | 115 | 85 |
| * Stabilizer bar link nuts - vehicles with Dynamic Response | 175 | 129 |
| * Upper arm to wheel knuckle nut | 70 | 52 |
| * Tie rod end ball joint nut | 76 | 56 |
| Brake hose retaining bracket to wheel knuckle bolt | 25 | 18 |
| *+ Halfshaft retaining nut | 230 | 169 |
| Road wheel nuts | 140 | 103 |
* New nut must be installed
+ Stake nut on completion