After Repair Procedure

After Repair Procedure

1. Cancel the memory of DTC's by disconnecting the negative battery cable for at least twenty seconds. Reconnect the negative battery cable.
2. Locate the OBD-II DLC (data link connector) and plug an OBD-II scan tool into it.
3. Turn the ignition switch ON.
4. Start and warm engine, then run at 2,000 rpm for three minutes.
5. Following the scan tool manufactures instructions, verify that no DTC '5 (diagnostic trouble codes) are recorded.
6. If DTC's are recorded, refer to Trouble Code Descriptions.
Diagnostic Trouble Code Descriptions