LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Cherokee Sport, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Ignition System (Service Information) >> Switch, Ignition >> Installation >> Installation

Switch, Ignition: Installation: Installation

  1. Install the Ignition Node Module into the Instrument Panel from the backside.
  2. Pull the Ignition Node Module into place.
    Fig 1: Removing/Installing Switch Mounting Screws
    GC0121041Courtesy of CHRYSLER GROUP, LLC
  3. Install 4 screws through the instrument Panel into the Ignition Node Module and tighten.
  4. Connect Electrical harness connector into Ignition Node Module.
  5. Install the Instrument Panel bezel and connect wire harness connectors. Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
  6. Install the HVAC control head and connect wire harness connectors. Refer to CONTROL, A/C AND HEATER, INSTALLATION .
  7. Install the steering column opening cover and connect the wire harness connectors.
  8. Install dash end cap. Refer to CAP, INSTRUMENT PANEL END, INSTALLATION .
  9. Connect negative battery cable.
  10. If Ignition Node Module is being replaced, program the module. Refer to STANDARD PROCEDURE . This procedure will require you to log into DealerCONNECT and enter a PIN when requested. The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN will need to be obtained from DealerCONNECT. 
scientia non olet · About LEMON Manuals