LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Wrangler Rubicon, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Installation >> 2.8L

Sensor, Coolant Temperature: Installation: 2.8L

WARNING: This page is about a different variant/trim than selected.
Fig 1: Thermostat Housing
GC0145357Courtesy of CHRYSLER GROUP, LLC
  1. Install coolant temperature sensor in thermostat housing. Tighten sensor to 11 N.m (8 ft. lbs.) torque.
  2. Install the thermostat housing onto engine. Refer to THERMOSTAT, INSTALLATION .
scientia non olet · About LEMON Manuals