Removal

REMOVAL
1. Disconnect negative battery cable at battery.




2. Disconnect vacuum line (2) at servo.

3. Disconnect electrical connector (6) at servo.

4. Remove coolant bottle nuts/bolts. Position bottle forward a few inches.

5. Disconnect servo cable at throttle body.

6. Remove servo bracket mounting nuts (3).




7. Remove two mounting nuts (1) holding servo cable sleeve to bracket.

8. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (3) and remove clip. Note: The servo mounting bracket displayed in graphic is a typical bracket and may/may not be applicable to this model vehicle.

9. Remove servo from mounting bracket. While removing, note orientation of servo to bracket.