Crankshaft Position Sensor: Service and Repair

Figure 6B-1 - Sensor to Crankshaft Reluctor Relationship, Ignition Coil Assembly,:

REMOVE OR DISCONNECT
1. Raise the vehicle and suitably support.
2. CKP sensor harness connector at module
3. CKP sensor mounting bolts
4. CKP sensor from engine
Inspect the CKP sensor 0-ring for wear, cracks or leakage. Replace if necessary. Lube new 0-ring with engine oil before installing.

INSTALL OR CONNECT
1. CKP sensor into block
2. CKP sensor mounting bolts
3. Tighten CKP sensor mounting bolt to 8 Nm (71 in. lbs.)
4. CKP sensor harness connector.
5. Lower the vehicle.