LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Genesis 3.8, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.8L >> Crankshaft Position Sensor (CKPS) >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then vertically remove the sensor from the transaxle housing.
    Fig 1: Crank Shaft Position Sensor And Mounting Bolt
    G10452222Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals