LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Elantra GT Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to: Body - "CRASH PAD LOWER PANEL ").

  3. Remove the steering column upper and lower shrouds.

    (Refer to: Body - "STEERING COLUMN SHROUD PANEL ").

  4. Remove the wiper switch.

    (Refer to: Body - "MULTIFUNCTION SWITCH ").

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the Key Warning/Immobilizer connector (A).
    Fig 1: Identifying Key Warning/Immobilizer Connector
    G10751849Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the screw, remove the Key warning switch and Key Illumination (B).
  8. Pushing lock pin with Key ACC.
  9. Remove the Key lock cylinder (A).
    Fig 2: Identifying Key Warning Switch And Ignition Switch Connector
    G10751850Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals