Component Inspection

Measure resistance between terminals 1 and 2 of the injector connector (Component side).

TEMPERATURE AND RESISTANCE SPECIFICATION

Temp. (°C)	Temp. (°F)	Resistance (Ω)	Temp. (°C)	Temp. (°F)	Resistance (Ω)
-20	-4	12.2 ~ 12.3	40	104	15.5 ~ 15.7
-10	14	12.9 ~ 13.1	50	122	16.1 ~ 16.3
0	32	13.3 ~ 13.5	60	140	16.6 ~ 16.8
10	50	13.9 ~ 14.0	80	176	17.7 ~ 17.9
20	68	14.4 ~ 14.6	100	212	18.8 ~ 19.0
30	86	15.0 ~ 15.2	120	248	19.9 ~ 20.1

Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Injector Connector

Courtesy of HYUNDAI MOTOR CO.

Is resistance within the specification?
YES : --> Go to next step as below.

NO : --> Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.