LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying The 4 Steering Column Nuts
    GM1701532Courtesy of GENERAL MOTORS CORP.
    CAUTION: In order to ensure the intended function of the steering column in a vehicle during a crash and in order to avoid personal injury to the driver, perform the following:
    • Tighten the steering column lower fasteners before you tighten the steering column upper fasteners. Failure to do this can damage the steering column.
    • Tighten the steering column fasteners to the specified torque. Overtightening the upper steering column fasteners could affect the steering column collapse.
    IMPORTANT: Install the two washers in the same location at the lower steering column bracket as marked in the previous step.
  1. Install the steering column and 2 washers to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 4 steering column nuts (1) using the procedure shown above.

    Tighten:  Tighten the nuts to 27 N.m (20 lb ft).

  3. Connect the upper intermediate steering shaft to the steering column. Refer to Upper Intermediate Steering Shaft Replacement .
  4. Connect the steering column electrical connectors.
  5. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Remove anti-rotation pin J 42640  from the steering column.
scientia non olet · About LEMON Manuals