LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2002 >> Insight Automatic CVT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Automatic Transmission (CVT) >> CVT >> Mode Switch Test

Mode Switch Test

  1. Remove the screws securing the mode switch, then remove the switch.
    Fig 1: Identifying Mode Switch Connector Terminals
    G03681973Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the connector from the switch.
  3. Check the S mode switch for continuity between connector terminals No. 2 and No. 3.

    There should be continuity while pressing the S mode switch, and no continuity when the switch released.

  4. Check the D mode switch for continuity between connector terminals No. 1 and No. 3.

    There should be continuity while pressing the D mode switch, and no continuity when the switch is released.

  5. If either switch is faulty, replace it.
  6. If the switch is OK, but switch failure occurred, check and repair the wire harness on the mode switch circuit.
scientia non olet · About LEMON Manuals