Electronic Stability Control (ESC) System
- Components and Components Location
- Description and Operation
- Schematic Diagram
- Troubleshooting
- Failure Diagnosis
- Notes
- Memory of Fail Code
- Failure Checkup
- Counter Measures In Fail
- Warning Lamp ON
- Standard Flow of Diagnostic Troubleshooting
- Notes With Regard To Diagnosis
- ABS Check Sheet
- ABS Does Not Operate.
- Inspection Procedures
- DTC Inspection
- Check The Power Supply Circuit For The Diagnosis
- Check The Ground Circuit For The Diagnosis
- Check For Continuity In The CAN Line
- Check The Power Source Of ABS Control Module
- Check For Poor Ground
- Problem Verification
- Check The Power Source For The ABS Warning Lamp
- Check The CAN Circuit Resistance For ABS Warning Lamp
- Check The CAN Circuit Wiring For ABS Warning Lamp
- Check DTC Output
- ABS Does Not Operate (Intermittently)
- Communication With GDS Is Not Possible. (Communication With Any System Is Not Possible.)
- Communication With GDS Is Not Possible (Communication With ABS Only Is Not Possible)
- When Ignition Key Is Turned ON (Engine OFF). The ABS Warning Lamp Does Not Light Up
- Failure Diagnosis
- EBD (Electronic Brake-force Distribution)
- ESC Control Unit
- Emergency Signal System
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
- ESC OFF Switch
- Steering Angle Sensor