Engine Controls - Diagnostic Methods (Diesel)

• Diagnostic Methods
  • Overview
• Diagnostic Procedures
  • Sufficient Clean Fuel
• Diagnostic Tools
  • Required Equipment
  • Recommended Equipment
• Scan Tool Setup and Functionality
  • Notes
  • Diesel Particulate Filter Manual Regeneration
    • Notes
    • Operator Commanded Regeneration
  • Power Balance Test
    • Notes
    • Relative Compression Test
• Vehicle Check/Preparation
  • Visual Checks
  • Vehicle Preparation
• Quick Test Description
  • Notes
  • Key On Engine Off (KOEO) On-Demand Self-Test
  • Key On Engine Running (KOER) On-Demand Self-Test
  • Retrieve Continuous Memory Diagnostic Trouble Codes (DTCs)
  • Key On Engine Off (KOEO) Injector Electrical Self-Test
  • Key On Engine Running (KOER) Glow Plug Monitoring Self-Test
  • Malfunction Indicator Lamp (MIL) DTCs
• Clear The Continuous Diagnostic Trouble Codes (DTCs) And Reset The Emission Monitors Information in The Powertrain Control Module (PCM)
  • Notes
  • Description
  • Clearing the PCM Adaptive Tables
• Resetting The Diesel Particulate Filter Parameter
  • Description
• Output State Control (OSC)
  • Notes
  • One Touch Integrated Start System
• Parameter Identification (PID)
  • Notes
  • Selecting Parameter Identification (PID)
  • Parameter Identification (PID) List
• Freeze Frame Data
  • Description
  • Accessing Freeze Frame PID Data
  • Resetting Vehicle Specific DTCs
  • On Board Diagnostic (OBD) PID Data Monitor
• Flash Electrically Erasable Programmable Read Only Memory (EEPROM)
  • Description
  • Programming the VID Block for a New PCM
  • Making Changes to the VID Block
  • Making Changes to the PCM Calibration
• Drive Cycles
  • Description
  • Drive Cycle Procedure
• Intermittent Diagnostic Techniques
  • Notes
  • Recreating the Fault
  • Accumulating Powertrain Control Module (PCM) Data
  • Analyzing PCM Data