Removal & Installation: Notes

CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery.

NOTE: Anytime battery or central junction box fuse No. 6 (15-amp) is disconnected, power sliding doors must be initialized before they will operate correctly. If Left Power Sliding Door Module (LPSDM) 12-pin harness connector C355 or Right Power Sliding Door Module (RPSDM) 12-pin harness connector C352 is disconnected, only associated power sliding door must be initialized. If any module, switch or sensor is replaced or if any related wiring is repaired, both power sliding doors must be initialized. See POWER SLIDING DOOR INITIALIZATION PROCEDURE under PROGRAMMING.