Solar Sensor: Service and Repair

Removal




1. Disconnect battery ground cable.
2. Using putty knife or similar tool, insert under LH or RH corner of the instrument panel defroster opening grille and pry up to release snap clips.

NOTE: Protect instrument panel surface during this procedure.

3. Disconnect electrical connector from A/C sunload sensor.
4. Remove A/C sunload sensor assembly from two mounting studs.

Installation
1. Install A/C sunload sensor assembly to instrument panel defroster opening grille by pushing A/C sunload sensor firmly over two mounting studs.
2. Connect electrical connector to A/C sunload sensor.
3. Install instrument panel defroster opening grille to instrument panel.
4. Connect battery ground cable.