LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2010 >> Caliber SXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Universal Transmitter >> TRANSMITTER, Universal >> Standard Procedure >> Reprogramming HOMELINK® Transmitter Codes >> Canadian Programming/Gate Programming

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner.

If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live), replace "Programming HomeLink®" step 3  with the following:

NOTE: When programming a garage door opener or gate operator, it is advised to unplug the device or move the vehicle out of range during the "cycling" process to prevent possible overheating.
  1. 3  Continue to press and hold the HomeLink® button while you press and release every two seconds  ("cycle") your hand-held transmitter until the frequency signal has successfully been accepted by HomeLink®. (The indicator light will flash slowly and then rapidly.) Proceed with "Programming" step  4 to complete.
scientia non olet · About LEMON Manuals