Diagnostic Test
- VERIFY COMPLAINT NOTE: Ensure that the battery is fully charged.
- Turn the ignition on.
- With the scan tool, read the active OCM DTC.
Does the Scan Tool report the ACTIVE: B2714-FLEX MAT SENSOR MISMATCH?
Yes
- Replace the Flex Mat Service Kit in accordance with the Service Information.
- Perform the OCM REZERO. Refer to DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .
WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.No
- Test Complete.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .