SWITCH, Ignition: Installation: Installation

Fig 1: INTER LOCK CABLE

Courtesy of CHRYSLER LLC

1 - Ignition Switch Assembly

2 - Shift Interlock Cable

1. Install shift interlock cable to ignition switch. Refer to Transmission and Transfer Case/Automatic - 40TE/CABLE, Shift Interlock - Installation .
   Fig 2: MODULE ELECTRICAL CONNECTOR

   Courtesy of CHRYSLER LLC
2. Push ignition switch up into connect electrical connectors.
   Fig 3: HOUSING BRACKET

   Courtesy of CHRYSLER LLC
3. Install location t on ignition switch into slot on instrument panel.
4. Pull ignition switch into place.
   Fig 4: SWITCH LOCATING PINS

   Courtesy of CHRYSLER LLC
5. Make sure that location pins are in place.
   Fig 5: SWITCH MOUNTING SCREWS

   Courtesy of CHRYSLER LLC
6. Install two front mounting screws and tighten.
   Fig 6: REAR MOUNTING SCREW AND WASHER

   Courtesy of CHRYSLER LLC
7. Rear mounting screw and washer.
   Fig 7: SWITCH REAR MOUNTING SCREW

   Courtesy of CHRYSLER LLC
8. Install rear mounting screw and washer and tighten.
   Fig 8: CLUSTER CONNECTORS

   Courtesy of CHRYSLER LLC
9. Connect two electrical connectors to the back of the instrument cluster
   Fig 9: CLUSTER RELOCATED

   Courtesy of CHRYSLER LLC
10. Relocate instrument cluster and install. Refer to Electrical/Instrument Cluster - Installation .
    Fig 10: SWITCH COVER

    Courtesy of CHRYSLER LLC
11. Install instrument cluster bezel. Refer to Body/Instrument Panel/BEZEL, Instrument Cluster - Installation .
    Fig 11: CENTER STACK BEZEL

    Courtesy of CHRYSLER LLC
12. Install radio bezel. Refer to Body/Instrument Panel/BEZEL, Instrument Panel - Installation .
    Fig 12: SWITCH

    Courtesy of CHRYSLER LLC
13. Connect negative battery cable.
14. Adjust shift interlock if necessary. Refer to Transmission and Transfer Case/Automatic - 40TE/CABLE, Shift Interlock - Adjustments .