LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Power Roof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  2. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .

    Tighten:  Tighten the motor attachment screws to 3.5 N.m (31 lb in).

  3. Connect the electrical connector to the motor/actuator.
    4. Fig 1: View Of Pin & Drive Motor
    GM1549380Courtesy of GENERAL MOTORS CORP.
  4. Remove the pin (1) from the holes that held the position while installing the drive motor.
  5. Install the headliner. Refer to Headliner Replacement (Impala) or Headliner Replacement (Monte Carlo) .
  6. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initilization/Teach Process .
  7. Verify the operation of the sunroof.
scientia non olet · About LEMON Manuals