LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Classic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Shift Control Replacement >> Installation Procedure

Installation Procedure

  1. Install the cable through the cowl and carpet.
    2. Fig 1: View Of Cable At Shift Control Assembly
    GM404880Courtesy of GENERAL MOTORS CORP.
  2. Install the cable grommet and the bolts in the cowl.

    Tighten:  Tighten the grommet bolts to 2 N.m (17 lb in).

  3. Install the cable (4) at the shift control assembly (3).
  4. Install the center control. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    5. Fig 2: Installing Cable At Transmission Cable Brackets
    GM183360Courtesy of GENERAL MOTORS CORP.
  5. Install the cable at the transmission cable brackets (1).
  6. Install the cable at the transmission selector lever (2).
  7. Install the negative battery cable.
  8. Adjust the cable.
  9. Place the shift lever in NEUTRAL. You can find NEUTRAL by rotating the selector shaft clockwise from PARK through REVERSE to NEUTRAL.
  10. Place the shift control assembly in NEUTRAL.
    11. Fig 3: Installing Automatic Transaxle Range Selector Cable Retainer To Console Shift Control
    GM161221Courtesy of GENERAL MOTORS CORP.
  11. Pull the cable locking clip fully upward.
  12. Push the on the cable adjuster in order to adjust cable in the cable mounting bracket.
scientia non olet · About LEMON Manuals