LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.0L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the electrical connector from the crankshaft position (CKP) sensor.
  2. Remove the transmission from the vehicle.
  3. Remove the flywheel or the flex plate from the crankshaft.
  4. Remove the 2 bolts (3) and the sensor wire harness clips or shield.
  5. Remove the bolt (4) securing the CKP sensor to the engine block (5).
  6. Remove the CKP sensor (1) and the wire harness (2) from the vehicle.
  7. Inspect the CKP sensor signal rotor for damaged or missing teeth through the CKP sensor opening.
    8. Fig 1: View Of Engine Block CKP Sensor, Wire Harness & Bolts
    GM451356Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals