LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2004 >> Tracker 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.5L (LE8) (Introduction) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

  1. Install ignition coil (2) into the valve cover.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the ignition coil to the engine with the retaining bolt (1).

    Tighten:  Tighten the retaining bolt to 10 N.m (89 lb in).

  3. Connect the ignition coil electrical connector.
    4. Fig 1: View Of Ignition Coil & Retaining Bolt
    GM677347Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition coil cover (2) to the valve cover (1).
  5. Secure the ignition coil cover (2) with the two fasteners.

    Tighten:  Tighten the two fasteners to 3 N.m (26 lb in).

    6. Fig 2: View Of Ignition Coil Cover Fasteners & Valve Cover
    GM739064Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals