Transaxle Range Switch: Removal

CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Disconnect the negative battery cable. Remove the TR switch electrical connector at the engine wiring harness. Remove the TR switch harness from the retaining clamps. Remove one bolt and the TR switch (4) from the transaxle. See Figure.