Removal Procedure

Disable the high voltage system. High Voltage Disabling
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel (2) - Remove - Air Inlet Grille Panel Replacement
Courtesy of GENERAL MOTORS COMPANY

Front End Sheet Metal Cross Brace (2) - Remove - Front End Sheet Metal Cross Brace Replacement
Courtesy of GENERAL MOTORS COMPANY

High Voltage Cable Connector Cover Bolt (1) - Remove [4x]
High Voltage Cable Connector Cover (2) - Remove [2x]
High Voltage Cable Connector Cover Seal (3) - DISCARD the seal. [2x]
Courtesy of GENERAL MOTORS COMPANY

High Voltage Terminal Bolt (1) - Remove [6x]
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Deflector Water Deflector (1) - Remove - Air Inlet Deflector Water Deflector Replacement
Courtesy of GENERAL MOTORS COMPANY

Protective Terminal Cover (2) - Remove
Cable Retainer Nut (1) - Remove
Drive Motor Power Inverter Module Connector (4) - Disconnect
Drive Motor Power Inverter Module 3-Phase Cable (3) - Remove
Raise and support the vehicle. Lifting and Jacking the Vehicle
Support the transmission with a suitable jack.
Transmission Support Crossmember - Remove - Transmission Support Crossmember Replacement (LTG without HP9)Transmission Support Crossmember Replacement (LTG with HP9)Transmission Support Crossmember Replacement (LGX, LGW)
Lower the transmission 40mm to access the high voltage cable covers.
Courtesy of GENERAL MOTORS COMPANY

Drive Motor Power Inverter Module 3-Phase Cable (4, 5) - Remove - Transmission Replacement
Courtesy of GENERAL MOTORS COMPANY

Cable Retainer Fastener (1) - Remove
Retainer (2) - Disengage
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Disconnect
Retainer (2) - Disengage [2x]
Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Panel Brace Nut (1) - Remove [4x]
Front Wheelhouse Panel Brace (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Wheelhouse Panel Brace Nut (1) - Remove
Drive Motor Power Inverter Module 3-Phase Cable (2) - Remove