LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1632 (Steering Linkage) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Idler Arm & Relay Rod
    GM1862675Courtesy of GENERAL MOTORS CORP.
  1. Position the relay rod (5) in the vehicle.
  2. Install the pitman arm (2) to the relay rod (5).
  3. Install the idler arm (1) to the relay rod.
    4. CAUTION: Refer to Fastener Caution .
  4. Install a NEW pitman arm nut (4) and tighten to 62 N.m (46 lb ft).
  5. Install a NEW idler arm nut (6) and tighten to 62 N.m (46 lb ft).
  6. Install the steering linkage outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement .
  7. Install the steering linkage shock absorber to the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement .
  8. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  9. Measure the wheel alignment. Refer to Wheel Alignment Measurement .
  10. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals