Installation Procedure

Fig 1: View Of Door Switch Assemblies & Door Switch Bezel

Courtesy of GENERAL MOTORS CORP.

Install the power window switch to the armrest switch plate applique. Push to engage the switch to the applique.
Connect the wire harness to the power window switch assembly.

Fig 2: View Of Front Door Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Install the power window switch assembly into the pocket in the door trim panel.
Remove any protective tape.

Fig 3: View Of Armrest Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the armrest to the door trim panel. Secure the armrest with 4 retaining screws at the rear and 1 screw at the forward end of the armrest assembly.
Tighten: Tighten the screws to 10 N.m (89 lb in).

Fig 4: View Of Door Panel Inner Energy Absorber

Courtesy of GENERAL MOTORS CORP.

Install the inner energy absorber to the door panel.
Install the upper trim to the door.
Install the retainers at the back of the door trim panel.
Tighten: Tighten the retainers to 10 N.m (89 lb in).
Install the door trim panel. Refer to Trim Panel Replacement - Door .