LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2014 >> Regal GS, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Rear Differential Clutch Control Module Programming and Setup >> Rear Drive Clutch Control Module Replacement

Rear Drive Clutch Control Module Replacement

NOTE:

The transfer case solenoid valve and the rear drive clutch control module must always be replaced together due to calibration reasons.

If the rear drive clutch control module needs to be replaced, the following procedures must be performed:

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
  2. Perform the SPS function Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
  3. Perform the SPS function Rear Differential Clutch Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration / Reconfiguration and ECU Setup.
  4. Clear DTCs after completing the programming procedure.
scientia non olet · About LEMON Manuals