Power Mirror Actuator

With DPMS:
1. Remove the door panel.




2. Disconnect the 12P connector (A) from the power mirror actuator (B).




3. Check actuator operation by connecting power and ground according to the table.
4. If the mirror fails to work properly, replace the mirror actuator.

Defogger Test
5. Check for continuity between the No. 6 and No. 7 terminals of the 12P connector. There should be continue.

Without DPMS:
1. Remove the door panel.




2. Disconnect the 8P connector (A) from the power mirror actuator (B).




3. Check actuator operation by connecting power and ground according to the table.
4. If the mirror fails to work properly, replace the mirror actuator.

Defogger Test
5. Check for continuity between the No. 1 and No. 4 terminals of the 8P connector. There should be continuity.